If your client has chosen the framed or overlay design, you will be adding front panels to give the unit the custom Sub-Zero look. You will not have to install front panels. If your client has chosen the stainless steel design, the unit will be shipped complete with wrapped stainless steel doors and handle hardware. Refer to the full-scale illustrations at the end of this section for specifics on door openings and filler size alternatives. In any side- by-side installation without a filler strip, add an additional 1/ 2" (13) to your combined numbers. This kit is available through your Sub-Zero dealer.īe sure to add the filler strip width to your finished rough opening dimension. An anchoring kit may also be used to attach two units together. The width of this filler strip will vary depending on the configuration and panels you use. When units are installed side by side, a filler strip is recommended. A 90˚ door stop is available as an accessory. If you're using raised panels, consider using a wider filler. Refer to the minimum door swing clearance in the specifications chart.įor corner installations, allow for a minimum 3" (76) filler so that the door can open to 90˚. With the door opening at 90˚, you may have to move drawers slightly to clear the door interior. More than 1/ 2” (13 mm) to 3/ 4” (19 mm) of bit is protruding.ĥ Attach the heater to the unit using the #8-32 × 1/ 2" pan head screws into the drilled holes.Refer to the illustrations and specifications for overall dimensions, finished rough opening dimensions and installation specifics.Īllow the door to open a minimum of 90˚ or you'll have problems removing drawers. Short drill bit inserted into the drill chuck so that no Note: To avoid drilling through the inner liner, use a Note: The heater assembly MUST be attached to the right side of the left-hand unit.ġ Clear the foil from the mounting holes of the heater assembly.Ģ Place the heater against the right-hand side of the unit with wires up and foil side in, positioning the heater 2” (51 mm) from the top edge of the cabinet and 1” (25 mm) from the rear edge of the cabinet.ģ Using the heater as a template, mark the heater mounting holes on the cabinet with a pencil, then remove the heater.Ĥ Drill a 7/ 64" (3 mm) hole at each marked location.
If a Built-In unit were to tip and fall, it could cause serious injury or death! The front leveling legs of a Built-In unit must be extended to the floor to complete the installation. The anti-tip components supplied with Built-In units must be used as specified in the installation guide. When moving a Built-In unit, keep the doors and drawers taped closed. Built-In units are heavy and can be unstable when attempting to install them.
0 kommentar(er)
